Paper Title :Cutting Temperature In High Speed Milling Of Silicon Carbide Using Diamond Coated Tool
Author :Mohammad Iqbal, Mohamed Konneh, Mohd Hanafi Bin, Kassim Abdulrahman Abdallah, Muhammad Faruq Bin Binting
Article Citation :Mohammad Iqbal ,Mohamed Konneh ,Mohd Hanafi Bin ,Kassim Abdulrahman Abdallah ,Muhammad Faruq Bin Binting ,
(2015 ) " Cutting Temperature In High Speed Milling Of Silicon Carbide Using Diamond Coated Tool " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 62-66,
Volume-3,Issue-4
Abstract : The present research studies the high speed milling process of Silicon Carbide, using diamond coated tool. The
effect of machining parameters such as cutting speed, feed rate and depth of cut on the cutting temperature were
investigated. The experiments were conducted under dry condition with two flute diamond coated flat end-mill of diameter 2
mm, using different spindle speeds (between 30,000 and 50,000 rpm), different feed rates (between 6 and 60 m/min), and
different depth of cuts (between 0.05 and 0.1 mm). Experimental results indicated that all the milling parameters influence
the cutting temperature. Cutting temperature increases with the increase of cutting speed at higher depth of cut, but decreases
at lower depth of cut. Increasing feed rate will increase cutting temperature at any conditions. Meanwhile, increasing depth
of cut will increase cutting temperature at lower feed rate, but decrease cutting temperature at higher level of feed rate. As
the conclusion, the combination of high spindle speed with low feed rate and low depth of cut minimizes cutting temperature
developed in high speed milling of SiC with diamond coated tool.
Keywords- Cutting Temperature, High speed milling, Silicon Carbide, Diamond Coated Tool.
Type : Research paper
Published : Volume-3,Issue-4
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-1917
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 97 |
| |
Published on 2015-04-14 |
|
