Paper Title :Optimization Of End Milling Parameters For Improving Surface Roughness Using Taguchi Method
Author :Shadab Anwar, Saleem Uz Zaman Khan
Article Citation :Shadab Anwar ,Saleem Uz Zaman Khan ,
(2016 ) " Optimization Of End Milling Parameters For Improving Surface Roughness Using Taguchi Method " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 6-9,
Volume-4,Issue-8
Abstract : Present paper presents a study that investigates the effect of the end milling machining parameters on the surface
roughness of the EN 31 steel. Nine experimental runs based on an orthogonal array of Taguchi method are performed and it
is subsequently applied to determine an optimal end milling parameter combination. Surface roughness is selected as the
quality target. The end milling machining parameters considered are rotational speed, feed rate and depth of cut. The feed
rate is found to be the most dominant parameter for surface roughness of EN 31 steel. Present study shows that high spindle
speed with small feed rate produce better surface finish and the effect of depth of cut is found to be negligible. Taguchi
method is used to obtain the optimal combination of end milling parameters.
Type : Research paper
Published : Volume-4,Issue-8
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-5247
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 111 |
| |
Published on 2016-08-24 |
|
