Paper Title :Optimization Of Turning Parameters By Using Taguchi Method For Optimum Surface Finish
Author :Aasheet Kumar, Gaurav Chaudhary, Manish Kalra, S.Manoj Prabhakar, Binit Kumar Jha
Article Citation :Aasheet Kumar ,Gaurav Chaudhary ,Manish Kalra ,S.Manoj Prabhakar ,Binit Kumar Jha ,
(2014 ) " Optimization Of Turning Parameters By Using Taguchi Method For Optimum Surface Finish " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 42-46,
Volume-2,Issue-5
Abstract : Abstract- It is well known that machining process monitoring is a crucial requirement in the successful implementation of
the automated / unmanned operation of a plant. In metal cutting process, the effectiveness of cost-quality-time matrix largely
depends upon the optimum selection of cutting parameters. In present approach, Taguchi method and analysis of variance
(ANOVA) is employed to develop a turning process model in terms of process parameters viz. cutting speed, feed rate and
depth of cut for achieving the optimum surface finish .This process model is then verified experimentally by machining
EN19 material.
Type : Research paper
Published : Volume-2,Issue-5
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-757
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 60 |
| |
Published on 2014-05-19 |
|
