Paper Title :Automatic Printed Part Removing System from 3D Printer

Author :Warat Chidchob, Siam Charoenseang

Article Citation :Warat Chidchob ,Siam Charoenseang , (2023 ) " Automatic Printed Part Removing System from 3D Printer " , International Journal of Electrical, Electronics and Data Communication (IJEEDC) , pp. 32-36, Volume-11,Issue-9

Abstract : This research project proposes an automatic printed part removing system from 3D printer used to handle defects in the 3D printing system. The proposed system automatically removes the printed parts from the 3D printer, making the entire printing process fully automated. The part removal system can be installed on various models of FDM (Fused Deposition Modeling) 3D printers available on the market.The system incorporates a load cell for measuring the force required to remove the printed parts. Experiments were conducted on PLA (Polylactic Acid) material with dimensions of 60x30x3mm at different angles: 0, 23, 45, 67, and 90 degrees. The results showed that an angle of 67 degrees was the most suitable for efficiently removing the printed parts.As of now, the part removal system has been tested in real-world scenarios with over 300 successful part removals, ranging from small parts with dimensions of 5x5x3mm to larger parts with dimensions of 89.28x100x20mm, achieving a success rate of 98.11%. Keywords - Automation, 3D Printer, 3D Printed Part Removal

Type : Research paper

Published : Volume-11,Issue-9

	|		PDF	|	Viewed - 36	|	Published on 2023-12-05