Paper Title :Optimization Of Surface Roughness Using Taguchi Method In End Milling Of Steel Grade En19 With Tin Coated Carbide Tool
Author :Vishal Parashar, Shailandra S. Bhadauria, Yogesh Sahu
Article Citation :Vishal Parashar ,Shailandra S. Bhadauria ,Yogesh Sahu ,
(2015 ) " Optimization Of Surface Roughness Using Taguchi Method In End Milling Of Steel Grade En19 With Tin Coated Carbide Tool " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 58-61,
Volume-3,Issue-2
Abstract : In this paper, the Taguchi method has been applied to optimize the machining performance in terms of surface
quality of the product, with EN 19 grade steel of cross section 100mm×100mm×20mm as the work piece. Tin-coated carbide
cutting tool having four flute 8mm diameter, shank length 30mm and cutter length 35mm is used for experiment on a vertical
milling machine SV-2E. Taguchi’s L9 orthogonal array is employed for the experimentation. The factors considered for
experimentation and analysis were cutting speed, feed rate and depth of cut. Signal-to-noise (S/N) ratio and analysis of
variance (ANOVA) were employed to analyze the effect of these milling parameters. The analysis results revealed that the
spindle speed was the dominant factor affecting surface roughness. Confirmation test results showed that the Taguchi method
was very successful in the optimization of machining parameters for minimum surface roughness.
Keywords— Analysis of variance (ANOVA), milling, surface roughness, Taguchi method
Type : Research paper
Published : Volume-3,Issue-2
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-1730
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 102 |
| |
Published on 2015-02-04 |
|
